-40%
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68
1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68

1967 1968 Mustang Cougar Console Body w Lights and Wiring Good Driver Cond 67 68

$ 100.29

Availability: 100 in stock
  • Brand: Ford
  • Returns Accepted: ReturnsNotAccepted
  • Country/Region of Manufacture: United States
  • Condition: Used
  • Warranty: No Warranty

    Description

    1967 1968 Mustang Cougar console body.  This body had several deficiencies which have been corrected.  It is a full length console, the forward panel has been epoxied in permanently.  Each upper side corner was cracked, so the PO cemented them crudely and backed up each side with a chip of wood.  Then he replace the fuzzy inside of the area to cover the wood supports.  Each lower radio bezel mounting stud flange had the top cracked off, so I glued a couple washers in place tor the attaching nuts .  The rear area of the console has part of the top missing.
    I replaced both of the rear convenience lamps and put a new male bullet connector on the under dash power harness supply wire and bench tested it. Both lights work properly.  The wiring harness also has 2 clips in place which would be held in place by the top bezel studs and nuts when installed.
    I have the nice radio bezel and some other parts from this console listed in other auctions,  Please give them a look.
    Shipping in lower 48,  .95